The easiest way to do this is with an electric drill and a 1 2 in 1 3 cm metal cutting drill bit.
Best way to cut corrugated metal roofing panels.
To begin get the power shear and align its cutting blades with the cutting line that you have marked on the underside of the metal sheeting.
Once you are satisfied with your measurements and alignment start cutting the metal.
Make the hole in the center of the part you wish to cut then trim toward the guideline you drew.
Want to cut iron lengthwise.
Here s a better way.
The ideal tool to perfectly cut corrugated metal is power shears.
Use a pair of snips if you want to avoid power tools altogether and are working with thinner more flexible metal or need to make curved cuts.
Sick of paying for expensive and smelly cutting disks.
Use a circular saw to make long straight cuts in thicker sheets of metal.
A circular saw equipped with a metal cutting blade will work just fine set the blade just deep enough to cut through the low parts of the corrugation and cut slowly.
The cheapest way to cut metal roofing is with a pair of tin snips.
Probably it s also the cheapest way for cutting corrugated tin roofing.
Make sure that they perfectly align with your measurements and remember that being even a tiny bit off can cause irreparable damage to your corrugated sheeting.
You want a pair of straight cuts or left or right handed pair for cutting both straight and around corners.
How to cut corrugated metal youcantoo i had a project recently that required that i cut a bunch of metal roofing into panels.
There are several ways to cut corrugated metal.
The best tin snips are good for cutting any edge of corrugated iron that is going to be seen as they are easy to control when cutting.
I am installing corrugated metal roofing what is the best way to cut the roofing to fit a valley.
To this point i have not had.
Make sure that it is perfectly aligned as being even a tiny bit out can cause irreparable damage to the sheeting.
Tin roofs are lightweight and soft by nature this is why cutting them manually with snips is a good option.
John la torre jr a builder in tuolumne calif replies.