Best Way To Remove Vinyl Tile Adhesive From Concrete Floor

Use a 3 4 or 1 in.

Best way to remove vinyl tile adhesive from concrete floor.

Scrape the remaining glue with a floor scraper or pry bar. Check the floor for vinyl tiles that are still stuck to the floor. Heat will soften vinyl enough for you to have a go at it with a putty knife. In these cases a solvent is needed to break down the glue so it can be scraped up.

Removing vinyl from concrete is similar to removing it from subfloor. Work the chisel under the tiles forcing them loose. Masonry chisel and a 2 lb. So removing this glue from the floor you need to use a commercial adhesive stripper to soften the glue.

4 repeat all steps until the tiles are completely removed from the. You can aim a blow gun at the vinyl or put it under several layers of paper and pass an iron over the top. If that doesn t get the glue off you will need to use a commercial adhesive stripper to soften and remove the glue. Sweep up dust or chipped pieces that come free and dispose of it all in the trash.

Soften the tile adhesive by blowing it with the hottest setting on the hair dryer and then scrape it with the putty knife. Start by scraping the glue with a pry bar or scraper. However getting the adhesive off the concrete may prove to be more difficult. The adhesive stripper will soften the glue and make it water soluble.

With vinyl the answer is fire or heat if you will. Depending on the adhesive a scraping is all you may need to remove it. The adhesive will only work if applied directly to the glue on the subfloor. Cut and pull up the vinyl in narrow strips to reveal the glue.

Sometimes heat and water are not enough to soften very old mastic and vinyl tile adhesive. You can use a commercial adhesive stripper or use acetone to soften and remove the glue as well as an electric hand sander for tough to remove spots. The tile should pop off easily leaving the glue in place. Start at a broken tile or between tiles where the grout has loosened.

Try a hand scraper first with protective gloves to avoid blisters but if the job proves too difficult you can try a power scraper or a scraper attachment on a reciprocating saw instead. If there are still several tiles stuck to the floor place a piece of dry ice on the tile. Thus you can easily sweep away the glue. Now you are all set.

Work the chisel between the tiles and the concrete hammering them up with a 2 lb.